Dark Light
,

Spring loaded Center Pin

Availability:

Out of stock


510 Connector Spring

EGP140.00

Spring loaded Center Pin

 22mm Diameter Brass 510 Connector Spring

Spring – Loaded Center Pin Brass 510 Connector 

– Copper Color

Descriptions

Main Features
• Only 1mm thick landing pad
Made of brass, durable and strong
• 22mm diameter
• Spring-loaded 510 center pin
• Solder ring terminal hole size: 10.4mm

Specification

General Type: Electronic Cigarettes Accessories
Accessories type: Other
Material: Brass
Available Color: Brass
Dimensions and Weight Product weight: 0.0080 kg
Package weight: 0.0200 kg
Product size (L x W x H): 3.60 x 2.20 x 1.50 cm / 1.42 x 0.87 x 0.59 inches
Package size (L x W x H): 4.60 x 3.20 x 2.50 cm / 1.81 x 1.26 x 0.98 inches
Package Contents Package Contents: 1 x Brass 510 Connector

Spring loaded Center PinSpring loaded Center PinSpring loaded Center Pin

Product Description
The Varitube 510 is here! A Bullet Proof Connector:

– NO Need to disassemble for soldering
– NO Threaded insulators to strip
– NO max wire gauge restrictions
– Solder before or after installation
Only 11.5mm long – note you need an additional 2.2mm-3mm to allow movement within the installation

Note – Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector … This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation. Pre-loading the spring with an over tightened T-Nut may result in ‘ratchety’ movement while installing an atomizer … Adjust the T-Nut prior to soldering!

Ultra low profile shoulder, self-adjusting spring loaded center pin, brass backer nut for solid and secure installation.

Made of Stainless, Brass, & High Temp insulating material this connector is perfect for box mods and the discerning modder!

The spring carries no electrical load!
22mm with Air Channels
22mm Smooth Top
Only 1mm thick landing pad
Made of Stainless with High Temp Insulator, and brass – rated for 450F degrees continuous service
Assembled connector length – 11.5mm – extends to about 14mm with atomizer installed
Body threading – M10x0.5 – 10mm diameter … about 3/8″
Ring Terminal for ground connection included
Does NOT need to be disassembled for soldering!!!

Huge productivity gain! Can be soldered after install as well if desired. Only adjustment needed is to make sure the bottom T-Nut is not over tightened prior to soldering.
Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector …

This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation. Pre-loading the spring with an over tightened T-Nut may result in ‘ratchety’ movement while installing an atomizer …

Adjust the T-Nut prior to soldering!
Ring Terminals Are Included

thecastleshop

elbatol.com

X